I’ve been all over the place with this machine so far, and this is where I am now. Any suggestions as to what direction I should be heading are appreciated. Rooted K1 Max/Orcaslicer/Duramic PLA/0.4mm nozzle @230⁰/speed: 50mm/retraction: 0.5mm @ 60mm second My starting flow ratio is 0.99 and my line width was at 0.34mm. I am playing with my Z offset and flow rate on the Fluidd interface as I go with these. The filament is dry. The flow settings shown on the pic are relative to the starting po
BAD First Layer Your K1 and K1 Max Printer? Here's how to get the best results.
First layer issue with K1 Max : r/crealityk1
BAD First Layer Your K1 and K1 Max Printer? Here's how to get the best results.
K1 MAX Bad first layer - Ecosystem Product - Creality Community Forum
Creality K1 Max 3D Printer with FREE 1KG PLA Filament, 600mm/s High-Speed FDM 3D Printing Smart AI Function 300°C High-Temperature Nozzle Direct Extruder Auto Leveling Printing Size 11.81x11.81x11.81
Bambu Lab P1S, 845.00 CHF
3D printing First Layer issues troubleshooting Guide
K1 first layer help : r/crealityk1
What You Need to Know About the Creality K1 Max
Gaps in 3D Prints: How to Fix & Avoid Them