First Layer Issues - Troubleshooting - V1 Engineering Forum

Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin

First Layer problems - Inconsistency – Assembly and first prints

Well, I'm getting started! - Troubleshooting - V1 Engineering Forum

Help! First Layer Issues – Assembly and first prints

Well, I'm getting started! - Troubleshooting - V1 Engineering Forum

first layer problems after upgrade to MK3S – Assembly and first

cdn./wp-content/uploads/firstlayer

How to Make the Perfect 3D Print First Layer

First layer problem with PETG - Irregular results – Assembly and

Strange first layer problem – Prusa i3 kit (Archive) – Prusa3D Forum

First layer issues – Assembly and first prints troubleshooting

3D print improvements - Troubleshooting - V1 Engineering Forum

P1S - Bad Prints, Troubleshot A Lot Already - Troubleshooting

Perfect first layer issues – Assembly and first prints